Owner`s manual

2 3 4 5
Learning Adventure
Game Cartridge
with Key Ring
Note: Tighten and loosen all screws with a Phillips screwdriver. Do not over-tighten.
Shown Actual Size
Parts
Back Base
(Large)
Handlebar
Front Base
(Small)
Adult assembly is Required. Required tool:
Phillips screwdriver (not included).
Seat Post
Pedal Assembly
Frame Cover (with Bolt)
Seat
Frame
with Console
#8 x 1,25" Screw - 14
Plug-and-Play Cord
Fit the pedal assembly into the groove in •
the underside of the frame, as shown.
Hint: The pedal assembly is designed to
only fi t one way. If it does not seem to
fi t, turn it around and try again.
Insert four screws into the pedal •
assembly. Fully tighten the screws.
Assembly
1
This product contains
small parts in an
unassembled state. Adult
assembly is required.
CAUTION
Pedal
Assembly
Frame
Front Base
(Small)
2
Fit the front base (small) onto the •
bottom of the frame, as shown.
Hint: The front base is designed to fi t
onto the frame one way. If it does not
seem to fi t, turn it around and try again.
Insert four screws into the front base •
and tighten.
Seat Post
Rear Base
(Large)
3
Fit the rear base (large) onto the end •
of the seat post, as shown.
Hint: The rear base is designed to fi t onto
the seat post one way. If it does not seem
to fi t, turn it around and try again.
Insert two screws into the rear base •
and tighten.
W5460
Please keep this owner’s manual for future reference, as it contains important information.
Requires four “D” (LR20) alkaline batteries (not included) for operation.
Age: 3-6 years.
This product is intended for indoor use only.
Use ONLY alkaline batteries for longest battery life.
PHYSICAL LEARNING ARCADE SYSTEM
www.fi sher-price.com
Assembly
4
Frame Cover
(with Bolt)
Insert the frame cover with bolt into the •
hole on the side of the frame assembly.
• Full tighten the bolt with a Phillips
screwdriver.
5
Handlebar
Fit the handlebar onto the frame, •
as shown.
Hint: The handlebar will only fi t one way
onto the console. If it does not seem to
fi t, turn it around and try again!
Insert two screws into the handlebar •
and tighten.
Pull up on the handlebar to be sure it •
is secure.
6
Turn both the frame and seat post •
assemblies upright.
Fit the seat post assembly onto the •
frame assembly.
Insert two screws into the seat post •
and tighten.
Hint: You may want to insert the
frame cover with bolt into the frame
assembly before inserting and
tightening screws in the post.
For your child's comfort, the seat can •
be adjusted to any of three seat heights
(upper slots for shorter children and
lower slots for taller children).
To remove the seat, press the tabs •
underneath and lift.
Replace the seat at the desired height •
and push down on the seat to be sure
it is secure in the slots in the seat post.
Assembly
8
Seat
At an angle, fi t the upper tabs on the •
front of the seat into the slots on the
seat post.
Lower the seat to fi t the bottom tabs •
on the seat into the slots on the seat
post. You should hear a "click".
Push down on the seat to be sure it •
is secure.
7
Seat Height 3
(Shortest)
Seat Height 2
Seat Height 1
(Tallest)
W
5460