User`s manual
20
OTHER INFORMATION
DISCLAIMER AND LIMITATION OF LIABILITY
VTech
®
  Electronics  North  America,  L.L.C.  and  its  suppliers  assume 
no responsibility  for  any  damage  or loss  resulting  from  the  use  of  this 
handbook. VTech
®
 Electronics  North  America,  L.L.C.  and  its  suppliers 
assume no responsibility for any loss or claims by third parties that may 
arise through the use of this software. VTech
®
 Electronics North America, 
L.L.C. and its suppliers assume no responsibility for any damage or loss 
caused by deletion  of  data  as a result of  malfunction,  dead battery, or 
repairs. Be sure to make backup copies of important data on other media 
to protect against data loss.
COMPANY:  VTech
®
 Electronics North America, L.L.C.
ADDRESS:  1155  West  Dundee  Rd,  Suite  130,  Arlington  Heights,  LL 
60004 USA
TEL NO.:  1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada
NOTE:
This equipment has been tested and found to comply with the limits for 
a Class  B digital device, pursuant to Part 15  of the FCC Rules. These 
limits  are  designed  to  provide  reasonable  protection  against  harmful 
interference in a residential installation. This equipment generates, uses 
and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio 
communications.  However,  there  is  no  guarantee  that  interference  will 
not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:
  Reorient or relocate the receiving antenna.
  Increase the separation between the equipment and receiver.
  Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.
  Consult the dealer or an experienced radio/TV technician for help.
Caution:  Changes  or  modifications  not  expressly  approved  by  the  party 
responsible for compliance could void the user’s authority to operate 
the equipment.
 OTHER INFORMATION










