User manual

Manual Ver1.0
- 22 -
Enter the following critical information in the VPN Tunnel Settings:
1. Enter a name for this IPSec connection.
2. Enter the Public IP address of the remote gateway in the next field.
3. Select “Subnet” for Tunnel access from local IP addresses.
4. Enter the network address for the “IP address for VPN” field. (If your IP is X.X.X.X the network
address is usually X.X.X.0 for class C addresses)
5. Enter the local subnet mask in the field.
6. Select “Subnet” for Tunnel access from local IP addresses.
7. Enter the network address for the “IP address for VPN” field. (Note: you can not have the same
network address for both local and remote networks.)
8. Enter the remote subnet mask in the next field.
9. Set the Key Exchange Method to “Auto(IKE)”
10. Select “Pre-Shared Key” for authentication method.
11. Enter a key for the “Pre-Shared Key” field.
12. Select Disable for “Perfect Forwarded Security”
13. Click “Save/Apply” to save this connection.
14. Click the Enable check box to activate this connection.
15. Configure the remote IPSec gateway in the same manner. However, the local ip parameters will
be remote ip parameters.
16. Once established, you can connect to clients in the remote network using their local IPs.