57900 Manua new.
57900 Manua new.
INTRODUCTION STEERING WHEEL ACTIVITY PANEL SEAT ARROW BUTTONS HORN BUTTON FLASHING LIGHTS SLIDING CAR Introduction Thank you for purchasing the VTech® Sit-to-Stand Smart Cruiser™ learning toy. Cruise into the learning zone on the Sit-to-Stand Smart Cruiser™ by VTech®. This 2-in-1 toy has an interactive steering wheel that includes driving, learning and music modes. Turn on the engine, move the gear shifter or press the horn to hear realistic driving sound effects.
- User’s manual 18 screws - 1 VTech® Sit-to-Stand Smart Cruiser™ steering wheel activity panel 1 vehicle body Handle bars - - 1 set of front wheels (includes an axle, two large brackets and two wheels) 1 set of back wheels (includes an axle, two small brackets and two wheels) 1 seat bracket 1 seat 57900 Manua new.
WARNING: All packing materials, such as tape, plastic sheets, packaging locks and tags are not part of this toy, and should be discarded for your child’s safety. ATTENTION: Pour la sécurité de votre enfant, débarrassez-vous de tous les produits d’emballage tels que rubans adhésifs, feuilles de plastique, attaches et étiquettes. Ils ne font pas partie du jouet. Pull out the packing locks NOTE: Please keep this instruction manual as it contains important information.
• • • • • • • • • • • • Use new alkaline batteries for maximum performance. Use only batteries of the same or equivalent type as recommended. Do not mix different types of batteries: alkaline, standard (carbonzinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries. Do not use damaged batteries. Insert batteries with the correct polarity. Do not short-circuit the battery terminals. Remove exhausted batteries from the toy. Remove batteries during long periods of non-use.
3. Insert the back wheels (includes an axle, two small brackets and two wheels) into the slot on the back of the vehicle body. Slide the two brackets out to lock the axle into place. Secure each bracket with 2 screws. 4. Insert the seat bracket into the top of the seat. Assembly Instructions 2. Insert the front wheels (includes an axle, two large brackets and two wheels) into the slot on the front of the vehicle body. Secure each bracket with 4 screws. 5.
PRODUCT FEATURES 1. ON/OFF/VOLUME CONTROL SWITCH 2. MODE SELECTOR SWITCH Slide the MODE SELECTOR SWITCH to the LEARNING MODE ( ), DRIVING MODE ( ) or MUSIC MODE ( ) position. 3. AUTOMATIC SHUT-OFF To preserve battery life, the VTech® Sit-to-Stand Smart Cruiser™ will automatically power-down after approximately 60 seconds without input. The unit can be turned on again by pressing any button. 57900 Manua new.
ACTIVITIES 1. Slide the on/off/volume control switch to turn the unit on. You will hear a welcoming phrase, playful sounds, short tunes and a sung song, depending on the selected mode. The lights will flash with the sound. 3. Slide the car back and forth to hear fun sounds or short tunes, depending on the selected mode. Stop sliding the car to hear fun sounds, playful phrases and short tunes, depending on the selected mode. The lights will flash with the sound. Activities 2.
5. Press the horn button to hear a variety of horn sounds and short tunes. The lights will flash with the sound. 7. Turn the ignition key to hear sounds and phrases or sung songs, depending on the selected mode. The light will flash with the sound. Activities 6. Press the left and right arrow buttons to hear the sounds, directional phrases or short tunes, depending on the selected mode. The lights will flash with the sound. 8.
1. London Bridge 2. Yankee Doodle 3. Sailing, Sailing 4. Clementine 5. Mulberry Bush 6. Three Blind Mice 7. Old McDonald 8. Farmer in the Dell 9. Chicken Reel 10. This Old Man 11. Baa, Baa, Black Sheep 12. Little Bo Peep 13. BINGO 14. Where Has My Little Dog Gone? 15. Pussy Cat, Pussy Cat 16. Three Little Kittens 17. Little Robin Red Breast 18. Listen to the Mocking Bird SUNG SONG LYRICS Melody List/Sung Song Lyrics MELODY LIST: SONG 1 Turn the key, spin the wheel, Drive the car to and fro.
CARE & MAINTENANCE 2. Keep the unit out of direct sunlight and away from any direct heat source. 3. Remove the batteries when the unit will not be in use for an extended period of time. 4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water. TROUBLESHOOTING If for some reason the program/activity stops working or malfunctions, please follow these steps: 1. Please turn the unit OFF. 2. Interrupt the power supply by removing the batteries. 3.
IMPORTANT NOTE: NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. CAN ICES-3 (B)/NMB-3(B) 57900 Manua new.indd 14 Other Info Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
