Installation guide

Synapse Installation Guide 43 [Headset] TL7600 Cordless Headset Installation
 To attach the behind-the-neck band to the Headset:
Figure 55. Headband and Earpiece
Figure 56. Insert Earpiece
The neckband ring is positioned for
wearing on the right ear when shipped.
1. To wear the Headset on your left ear:
a. Rotate the ring post up and
through the small socket opening,
as shown in Figure 55.
b. Snap the ring into the small
socket under the end of the left
arm of the neckband.
2. Insert the earpiece into the neckband
ring as shown in Figure 56.
3. Adjust and rotate the angle of the Headset until the microphone is pointing
toward your mouth as shown in Figure 57.
Firmly grip the earpiece with one hand whenever adjusting the Headset
microphone up or down.
4. To remove the Headset from the neckband:
a. Hold the Headset with one hand and the headband ring with the other
hand.
b. Twist and pull the Headset until it separates from the ring of the headband.
Socket
Opening
Ring Post
Earpiece
Neckband
Figure 57. Adjust Microphone
Headband