Installation guide

Synapse Installation Guide 42 [Headset] TL7600 Cordless Headset Installation
 To attach the over-the-head band to the Headset:
Figure 52. Headband and Earpiece
Figure 53. Insert Earpiece
1. Identify the earpiece and headband
as shown in Figure 52.
2. Push the earpiece towards the
headband ring until it clicks into
place as shown in Figure 53.
3. Adjust the headband to fit your head
as shown in Figure 54.
4. Adjust and rotate the angle of the
Headset until the microphone is
pointing toward your mouth as
shown in Figure 54.
5. To wear on the other ear, rotate the
Headset within the headband ring.
Firmly grip the earpiece with one hand whenever adjusting the Headset
microphone up or down.
6. To remove the Headset from the headband:
a. Hold the Headset with one hand and the headband ring with the other
hand.
b. Twist and pull the Headset until it separates from the ring of the headband.
Earpiece
Headband
Headband
Ring
Headband
Adjust
Figure 54. Adjust Headband and
Microphone