Installation guide

Synapse Installation Guide 36 [Handset] SB67040 Cordless Handset Installation
[Handset] Battery Charging
Charge the Handset battery for at least 16 hours before use. When fully charged, the Handset battery provides approximately
five hours of talk time or three days of standby time.
 To charge the Handset battery:
Figure 40. Handset in Charger
Place the Handset in the Charger, as shown
in Figure 40.
 The CHARGE light is on when the
Handset is charging.
 If the Handset has not yet been
registered, the Register screen shown
in Figure 41 displays within 15
seconds.
Charge Light
12:00a Jan. 0012:00a Jan. 00
To register Handset:
1. Go to your
Deskset.
2. Press MENU.
3. Select User
REGISTER 1/3
Figure 41. Register Screen
NOTE: Place the Handset in the Charger when not in use.