Installation guide

Synapse Installation Guide 34 [Handset] SB67040 Cordless Handset Installation
[Handset] SB67040 Cordless Handset Installation
[Handset] Charger Installation
The Handset uses a rechargeable 2.4V nickel-metal hydride cell (NiMH) pack and comes with a battery Charger. Place the Handset
in the Charger when not in use.
 To plug the Handset Charger into AC power:
Figure 37. Handset Charger Power Connect
1. Plug the power adapter into an electrical outlet not controlled by a
wall switch.
2. Plug the small end of the power adapter into the jack on the
underside of the Charger.
3. Route the cord through the slot, as shown in Figure 37.