Installation guide

Synapse Installation Guide 32 [ATA] Optional ATA Installation
 To install an overhead paging system:
1. Remove the plastic covers from the FXS 1 or FXS 2 (telephone) port to be used on the ATA.
2. Plug the telephone line from the OHP device into the ATA FXS 1 or FXS 2 port, or plug an audio cable from the OHP device
into the Synapse AUX OUT jack, as shown in Figure 35, depending on the requirements of the paging system.
3. Enable the OHP device in the WebUI.
See the Web User Interface (WebUI) chapter of the “Synapse Administrator’s Guide” for information on configuring an
OHP device at
www.telephones.att.com/synapseguides.
Figure 35. ATA Overhead Paging System Installation
Overhead
Paging
System
ATA