Installation guide

Synapse Installation Guide 30 [ATA] Optional ATA Installation
[ATA] Connecting a Fax Machine
 To install a fax machine:
1. Remove the plastic covers from the FXS 1 or FXS 2 (telephone) port to be used on the ATA.
2. Plug a telephone line from the fax machine into the ATA FXS 1 or FXS 2 port, as shown in Figure 34.
3. Configure the fax connection in the WebUI.
See “[ATA] Fax Settings” in the Synapse Administrator’s Guide for information on configuring the ATA to work with your
fax machine at
www.telephones.att.com/synapseguides.
Figure 34. ATA Fax Machine Installation
Fax Machine
ATA
If you are connecting your fax machine to the ATA, you will have to tell the employees that a 9 must be dialed
because the fax is now integrated into the Synapse system.