Installation guide

Synapse Installation Guide 23 Deskset Installation
 To install the Deskset on a wall:
Figure 25. Deskset Wall Mount
1. Plug the Ethernet cable into the port on the back of the
deskset. (See “To connect the RJ-45 Ethernet cable to the
Deskset:” on page 21.)
2. Plug the power adapter into the jack on the back of the
deskset. (See “To connect power:” on page 22.)
3. Place the Deskset base over the mounting plate above the
mounting studs as shown in .
4. Slide the Deskset base down as shown in .
5. Plug the Ethernet cable into the wall jack.
6. Plug the power adapter into a power outlet not controlled
by a wall switch.
7. Make sure the Handset Tab is in Wall position, as
described in “To rotate the Handset tab for wall and
Deskset Option 2 installation:” on page 20.
8. Connect the corded handset.
Wall-
Mount
Screws