Installation guide

Synapse Installation Guide 14 Gateway Installation
 To ground the Gateway:
1. Locate the Gateway within three feet (91.44 centimeters) of the building ground point, usually located at the electrical
breaker box.
2. Loosen the screw retaining the silver grounding terminal on the back of the Gateway, as identified in Figure 11.
3. Insert the spade/fork end of the grounding cable under the grounding terminal.
4. Tighten the screw.
5. Connect the alligator clip end of the grounding cable to the building ground point, usually located at the electrical breaker
box.
Figure 11. Gateway Grounding
If you are unsure about the location of the building ground point or how to ground the Gateway, contact the
facilities manager.
Grounding Terminal (Back Panel)