Installation guide

Synapse Installation Guide 13 Gateway Installation
Gateway Installation
You can place the Gateway on a tabletop or mount it into a standard 19” metal rack. The Gateway must be installed within three
feet of the building ground point. Install each Gateway using the following instructions.
 To mount the Gateway or ATA into a standard 19” rack:
Figure 8. Rack-mount Bracket
1. Remove the two mounting brackets and six screws from the packing tissue.
2. Position the right bracket at the front of the device, as shown in Figure 8.
3. To align the screw holes, place the
bracket on the device so that the
locating indent on the bracket matches
the indent on the device.
4. Insert each of the three screws into the
holes provided and tighten securely as
shown in Figure 9. Repeat the process
for the left bracket.
5. Position the chassis into the 19” metal
rack, as shown in Figure 10.
6. Insert a top mounting screw (not included) in one side and turn it several turns
to establish support. Repeat for the other side.
7. Tighten the screws.
Figure 10. Rack Installation
Mounting Screw
Holes
Locating Indent
Mounting Bracket
Figure 9. Bracket Installed