Specifications

www.vtechphones.com
3
Getting started
Basic operation
Getting started
If the handset
will not be used
for a long time,
disconnect and
remove the battery
to prevent possible
leakage.
To purchase
replacement
batteries, visit our
website at www.
vtechphones.
com or call
1 [phone].
In Canada, go to
www.vtechcanada.
com or call
1 [phone].
•
•
Battery installation and charging
Install the battery as shown below. The battery may have enough charge for short
calls. For best performance, charge the handset for at least 16 hours. When the
battery power is low, the handset will beep, LOW BATTERY will be displayed and
will ash on the handset screen. Place the handset in the telephone base or
charger to charge the battery when not in use. When fully charged, the handset
battery provides approximately eight hours of talk time or four and a half days of
standby time.
Insert the plug of the battery as indicated. Make sure it is plugged securely
and matches the color-coded label inside the battery compartment.
Place the battery with the label
THIS SIDE UP facing up and the wires inside
the battery compartment.
Align the battery compartment cover at against the battery compartment,
then slide it upwards until it clicks into place.
Charge the handset by placing it in the telephone base or charger. The handset
charge light will be on when charging.
1.
2.
3.
4.
1
2
3
4
Charge light
FLASH
CLEAR
SELECT
MENU
CID
VOL