User`s manual

85
The handset displays Registering handset... then HANDSET X Registered
and you hear a conrmation tone when the registration is successful. It takes about
60 seconds to complete the registration process.
If the registration fails, the handset displays Registration failed. Try the registration
process again.
You cannot register a handset if any other system handset is in use.
If you have not set the date and time for the telephone system, the handset will
prompt you to set the date and time after it is registered to the base. To skip setting,
press CANCEL.
2.
•
•
Expand your telephone system
The cordless handset provided within your product package is already registered as
HANDSET 1. The doorbell provided within your product package is already registered
as Doorbell 1.
This telephone system accommodates up to 10 handsets, including a maximum of
two doorbells. You can add new handsets (IS7101, purchased separately) or new
doorbell (IS741, purchased separately) to your telephone base. Each new handset or
doorbell must be registered with the telephone base before use. Additional handsets
and doorbell registered to the telephone system are assigned numbers in the
sequential order.
Add and register a handset
When rst purchased, each expansion handset shows Put handset on BASE to
register. The new handset should be charged without interruption for at least 30
minutes before registering it to the telephone base.
To register a handset:
Make sure the handset is out of the telephone base or charger and shows
Put handset on BASE to register. Place the handset you wish to register in
the telephone base.
1.
Do not place the handset in the
charger.
Appendix