User`s manual

Appendix
94
Troubleshooting
Out of range or No power at base appears on my cordless handset.
Ensure you plug the telephone base in properly and the power is on.
Place the cordless handset closer to the telephone base for synchronization.
Move the cordless handset closer to the telephone base. You may have moved out
of range.
Reset the telephone base. Unplug the electrical power. Wait for 15 seconds then
plug it back in. Allow up to one minute for the cordless handset and telephone base
to reset.
Other electronic products such as HAM radios and other DECT phones can cause
interference with your cordless phone. Try installing your phone as far away as
possible from these types of electronic devices.
The battery does not charge in the handset, or the handset battery does
not accept charge.
If the cordless handset is in the telephone base and the charge light is not on, refer
to The charge light is off (page 98).
Charge the battery in the cordless handset for at least 11 hours. For optimum daily
performance, return the cordless handset to the telephone base when not in use.
If the battery is completely depleted, charge the handset for at least 30 minutes
before use (page 4).
You may need to purchase a new battery. Please refer to Handset battery
installation (page 3) and Handset battery charging (page 4).
There is no chime from the doorbell when it is pressed.
Make sure you install two AA batteries and connect AC power supply to
the doorbell.
The doorbell light on the doorbell flashes when the doorbell is pressed. If the light
doesn’t flash, the doorbell may have run out of battery. You may need to replace
new batteries.
Make sure the doorbell is registered to the telephone system.
•
•
•
•
•
•
•
•
•
•
•
•