User`s manual

8
Use the existing Ethernet wall jack:
Use the PC port on the deskset as an Internet pass-through.
1. Unplug your Ethernet cable of your computer from the existing Ethernet wall
jack.
2. Plug one end of the Ethernet cable into the Ethernet port (
Use only
Supplied
Adapter
L4 L3/4 L2 L1/2
5.1
MS2085 Engraving:
MS2015 Engraving:
Use only
Supplied
Adapter
) at the back of
the deskset and the other end into the Ethernet wall jack.
3. Connect your computer to the Ethernet network through the PC port (
Use only
Supplied
Adapter
L4 L3/4 L2 L1/2
5.1
MS2085 Engraving:
MS2015 Engraving:
Use only
Supplied
Adapter
) of
the deskset.
NOTES:
• The PC port does not function when there is no power connected to this deskset.
• This telephone system does not support Power over Ethernet (PoE).
• If you are using the Gigabit system, the connection speed of your computer will be slower.
Set up a new network:
Contact your technical support for the Ethernet network setup.
Make sure your Ethernet switch or router has enough slots to accommodate
the console, each deskset and your computers.
Getting started
Planning your system
Use only
Supplied
Adapter