Operating instructions

13
Basic Operation
Your ia 5859 can store up to nine telephone numbers with names (up to 15 characters
and 24 digits in each location) in the dpeed dial memory locations you assign (num-
bered 1 through 9) in each handset. These numbers can be dialed with two button
presses. You can also store telephone numbers with names alphabetically in
the directory. See Telephone Directory for instructions.
NOTES:
1. The entries you store in speed dial memory will be marked with 01 through
09 and also display in the directory.
2. Press
(off) at any time to exit memory dial mode.
Store a Number/Name in Memory
1. Press prog. Then press until the screen displays
SPEED DIALSPEED DIAL
SPEED DIALSPEED DIAL
SPEED DIAL.
2. Press SELECT. The screen displays ENTER 1-9.
NOTE: When memory is full the screen displays MEMORY FULL, an error tone
sounds and you cannot store a new number until you delete a record in speed
dial memory or telephone directory.
3. Press the key (1 through 9) to assign the memory location this number will
be stored. The screen displays
ENTER NAMEENTER NAME
ENTER NAMEENTER NAME
ENTER NAME.
NOTE: If the location is not empty, your new entry will be stored in place of the old
and will delete the former entry. Take caution to not save over entries you do not
wish to delete from memory.
4. Using the chart below, enter up to 15 characters for the name you’re storing.
Use
to backspace and make corrections; use to advance and add a
space.
Speed Dial Memory
1: 1
2: A B C 2
3: D E F 3
4: G H I 4
5: J K L 5
6: M N O 6
7: P Q R S 7
8: T U V 8
9: W X Y Z 9
0: 0
*: *
#: & ’ , - . #
Presses
Dial Key 1 2 3 4 5 6