User`s manual

Basic Operation

Your ia 5851 can store up to nine telephone numbers with names (up to 15 characters

and 24 digits in each location) in the speed dial memory locations you assign (num-

bered 1 through 9). You can also store telephone numbers with names alphabeti-

cally in the directory. See Telephone Directory for instructions.

NOTES:

1. The entries you store in speed dial memory will be marked with 01 through 09

and also display in the directory.

2. Press

(off) at any time to exit memory mode.

Store a Number/Name in Memory

1. Press PROG. Then press until the screen displays

SPEED DIALSPEED DIAL

SPEED DIAL.

2. Press SELECT. The screen displays

ENTER 1-9ENTER 1-9

ENTER 1-9.

NOTE: When memory is full the screen displays MEMORY FULL, an error

tone sounds, and you cannot store a new number until you delete a record

in speed dial memory.

3. Press the key (1 through 9) to assign the memory location this number will be

stored, the screen displays

ENTER NAMEENTER NAME

ENTER NAME.

NOTE: If the location is not empty, your new entry will be stored in place of the old

and will delete the former entry. Take caution to not save over entries you do not

wish to delete from memory.

4. Using the chart below, enter up to 15 characters for the name you’re storing.

Use

to backspace and make corrections; use to add a space.

Speed Dial Memory

1: 1

2: A B C 2

3: D E F 3

4: G H I 4

5: J K L 5

6: M N O 6

7: P Q R S 7

8: T U V 8

9: W X Y Z 9

0: 0

*: *

#: & ’ , - . #

Presses

Dial Key 1 2 3 4 5 6