Telephone Owner Manual

www.vtechphones.com
29
Answering system operation
Answering system setup
Set remote access code
A two-digit security code is required to access the answering system
from any touch tone telephone. The factory default code is 19. To set the
remote access code:
• Press
SETUP in idle mode until the system announces the remote
access code setting.
•
Press /SKIP or /REPEAT to change the remote access code by one,
or press and hold /SKIP or /REPEAT to change by increments of 10.
Press SETUP to save the setting and go to the next setting or press
/PLAY/STOP to save and return to idle mode.
Set message alert tone
This feature programs the system to beep every 10 seconds to alert you
of new messages. The beeping will stop when all new messages have
been reviewed. To set the message alert tone:
• Press
SETUP in idle mode until the system announces the message
alert tone setting.
• Press
/SKIP or /REPEAT to select between on or off, then press
SETUP to save the setting and go to the next setting or press /PLAY/
STOP to save and return to idle mode.
• The answering
system must be
turned on for
the message
alert tone to
function.