User`s manual

Handset settings
17
Answering system settings
Number of rings
You can set the answering system to answer an incoming call after two, four,
or six rings. You can also select toll saver, which is explained below. Unless
you change it, the answering system answers an incoming call after four
rings.
To set the number of rings:
1. When the handset is in idle mode, press MENU/ SELECT to enter the main
menu.
2. Press
MENU /SELECT again.
3. Press
T CID or DIR S to scroll to >ANS SYS SETUP , then press MENU /SELECT .
4. Press
T CID or DIR S to scroll to ># OF RINGS , then press MENU /SELECT .
5. Press
T CID or DIR S to scroll and choose among 2 , 4 , 6 or TOLL SAVER .
• Toll saver - the answering system answers a call after two rings if you
have new messages, and after four rings when there are no new
messages. This feature allows you to check for new messages and
avoid paying long distance charges if you are calling from out of your
local area.
6. Press MENU /SELECT to confirm your setting. A confirmation tone sounds.
Remote access code
To access your answering system remotely from any touch
tone phone, you need to enter a two-digit number (10-99).
Unless you change it, the remote access code is 19.
To change the remote access code:
1. When the handset is in idle mode, press MENU/
SELECT to
enter the main menu.
2. Press MENU
/SELECT again.
3. Press TCID or DIRS to scroll to >ANS SYS SETUP, then
press MENU/SELECT.
4. Press TCID or DIRS to scroll to >REMOTE CODE, then
press
MENU/SELECT.
5. Press TCID or DIRS to change the remote access code.
6. Press
MENU/SELECT to confirm your setting. A
confirmation tone sounds.
NOTE: If you subscribe to caller ID/call waiting service through your telephone
service provider, see Answering system and voicemail on page 37.
QMBZ!NTHT
?BOT!TZT!TFUVQ
NTH!BMFSU!UPOF
?SFNPUF!DPEF
2:
SFNPUF!DPEF
EJSFDUPSZ
?BOT/!TZTUFN