User Manual

59
may make changes in its facilities,
equipment, operation, or procedures
that could affect the proper functioning
of this product. The telephone service
provider is required to notify you if such
changes are planned.
If this product is equipped with a corded
or cordless handset, it is hearing aid
compatible.
If this product has memory dialing
locations, you may choose to store
emergency telephone numbers (e.g.,
police, fire, medical) in these locations.
If you do store or test emergency
numbers, please:
Remain on the line and briefly explain
the reason for the call before hanging up.
Perform such activities in off-peak hours,
such as early morning or late evening.
Industry Canada
Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that
may cause undesired operation.
Privacy of communications may not be
ensured when using this phone.
The term ‘’IC:‘’ before the certification/
registration number only signifies
that the Industry Canada technical
specifications were met.
The Ringer Equivalence Number (REN)
for this terminal equipment is 0.1. The
REN indicates the maximum number
of devices allowed to be connected to
a telephone interface. The termination
of an interface may consist of any
combination of devices subject only
to the requirement that the sum of the
RENs of all the devices not exceed five.
This product meets the applicable
Innovation, Science and Economic
Development Canada technical
specifications.
California Energy
Commission battery
charging testing
instructions
This telephone is set up to comply
with the energy-conserving standards
right out of the box. These instructions
are intended for California Energy
Commission (CEC) compliance testing
only.
When the CEC battery charging
testing mode is activated, all telephone
functions, except battery charging, will
be disabled.
To activate the CEC battery
charging testing mode:
Unplug the telephone base power
adapter from the power outlet. Make
sure all handsets are plugged with
charged batteries before proceeding.
While you press and hold
FIND HANDSET, plug the telephone
base power adapter back to the power
outlet.
After about 20 seconds, when the
IN USE light starts flashing, release
FIND HANDSET and then press it
again within 2 seconds.
The process takes up to one minute to
complete. When the phone successfully
enters the CEC battery charging testing
mode, the IN USE light turns off and all
handsets display To register HS... and
...see manual alternately.
NOTE
When the phone fails to enter this mode,
repeat Step 1 through Step 3 above. The
telephone base will be powered up as
normal if you fail to press
FIND HANDSET within 2 seconds in
Step 3.
1.
2.
3.
•