User`s manual

55
9.1.6 Answer machine settings
9.1.6.1 Set the answer mode
You can set answer mode to choose which outgoing message you want played to callers.
ANSWER & RECORD -- The pre-set Answer & Record outgoing message, which allows your caller to leave a message.
ANSWER ONLY -- The pre-set Answer Only outgoing message, where callers hear an announcement but cannot
leave a message.
1. In standby mode, press
N and then +/- to select ANSWERING SYS.
2. Press
N then +/- to select ANS SYS SETUP.
3. Press
N then +/- to select ANSWER MODE.
4. Press
N then +/- to select ANSWER & RECORD or ANSWER ONLY.
5. Press
N to confirm
9.1.6.2 Set the answer delay
1. In standby mode, press
N and then +/- to select ANSWERING SYS.
2. Press
N then +/- to select ANS SYS SETUP.
3. Press
N then +/- to select # OF RINGS.
4. Press
N then +/- to select from 2 RINGS, 4 RINGS, 6 RINGS, 8 RINGS or TIME SAVER.
5. Press
N to confirm.
Note:
If Time saver setting is selected, the answering machine will pick up after two rings if there are new messages and after six
rings if there are no messages.