User`s manual

Phone settings
50
8.2.2 Set the flash time
The default flash time is suitable for your country and network operator. It is unlikely that you should need to change this
setting unless advised to do so.
1. In standby mode, press
N then +/- to select SETTINGS.
2. Press
N then +/- to select FLASH TIME.
3. Press
N then +/- to select the flash time from 80 MS, 100 MS, 120 MS, 180 MS, 200 MS, 250 MS, 300 MS and
600 MS.
4. Press
N to save.
8.2.3 Change system PIN
1. In standby mode, press N then +/- to select SETTINGS.
2. Press
N then +/- to select SYSTEM PIN.
3. Press
N then use the keypad to enter old 4-digit PIN (the default 4-digit PIN is 0000).
4. Press
N then use the keypad to enter new 4-digit PIN.
5. Repeat step 4 to enter the new 4-digit PIN again.
6. Press
N to confirm.