User`s manual

17
Auto connection
When a device is successfully paired with the telephone base but not connected, the handset displays HEADSET SETUP
COMPLETED DEVICE NOT CONNECTED and then AUTO-CONNECT FUNCTION ENABLED PRESS OK. You can press
N to exit. You can also connect a device manually.
4.6 Paired devices
• All paired devices are stored on the Paired devices list. Up to four devices (one headset only) can be paired with the
telephone base.
• To use a paired device, it must be connected and on the active devices list (page 18).
• Once you have paired a device with the telephone base, you do not need to repeat the pairing procedure again unless
you delete the device from the paired devices list.
Note:
Only the first 15 characters of the device name are shown on the paired devices list.
4.6.1 Rename a paired device
You can change the name of a paired device on the paired devices list.
1. In standby mode, Press
N then +/- select to BLUETOOTH.
2. Press
N then +/- to select PAIRED DEVICES.
3. Press
N then +/- to select a device when necessary.
4. Press
N then +/- to select RENAME.
5. Press
N. The screen displays ENTER NEW NAME.
6. Use the keypad to edit the name (see Writing tips on page 10).
7. Press
N to confirm. The handset displays DEVICE RENAMED.