User`s manual

Bluetooth

4. Press N. The screen displays PLEASE SET YOUR HEADSET TO DISCOVERABLE MODE, THEN PRESS OK.

• If a device is already connected to the telephone base, the screen displays CONNECTED DEVICE WILL BE

TEMPORARILY DISCONNECTED. PRESS OK. Press

N to temporarily disconnect the device and continue the

pairing process.

5. Set your headset to discoverable mode (refer to the User Manual of your headset).

6. Press

N to search for your headset.

7. Once the telephone base finds your headset, press

8. Enter the PIN of your headset (the PIN for most Bluetooth devices is 0000), then press

9. When the handset displays HEADSET A PAIRED TO BASE. CONNECT NOW? PRESS OK, then press

N on the

handset.

• When you already have two devices on the active devices list, the handset shows MAXIMUM OF 2 DEVICES CAN

BE CONNECTED. You are prompted to replace an existing headset on the active devices list.

• When you already have one headset on the active devices list, the handset shows ONLY 1 HEADSET CAN BE

CONNECTED. You are prompted to replace the headset on the active devices list.

10. When a device is successfully connected, the handset displays HEADSET SETUP COMPLETED DEVICE

CONNECTED and the corresponding status icon (

or ). The corresponding light on the telephone base

(DEVICE1 or DEVICE2) turns on.

Note:

The pairing process may take up to one minute. If the pairing process fails, try again. If you put the handset back in the

telephone base or charger while pairing, the process discontinues and the handset returns to idle mode.