User`s manual

4
Getting started
Add and register a handset
You can add new handsets (DS6301, purchased separately) to your
telephone system, but each handset must be registered with the telephone
base before use. When rst purchased, each expansion handset shows
Press and hold FIND HANDSET on base for 4 sec, then press # on
handset after a battery is installed. You may need to charge the handset
before registering to the telephone base. For more details on battery
charging, see the table on page 3.
To register a handset:
Press and hold /FIND HANDSET on the telephone base for about four
seconds until the red IN USE light turns on.
Press # (pound key) on the handset. Its screen shows Registering...
Please wait and it takes up to 60 seconds to complete the registration.
The handset shows HANDSET X Registered (X represents the handset
number assigned) and you hear a beep when the registration
is completed.
1.
2.
If the registration fails, the handset shows Registration failed for a few
seconds and then Press and hold FIND HANDSET on base for 4 sec,
then press # on handset. Try the registration process again.
You cannot register a handset if any other system handset is in use.
•
•