User Manual
Table Of Contents
- What’s in the box
- Overview
- Connect
- Before use
- Configure your telephone
- Headset usage
- Telephone operations
- Redial list
- Multiple handset use
- Phonebook
- Caller ID
- Smart call blocker*
- Call categories
- Call controls
- Set Smart call blocker on/off
- Control calls without numbers
- Control uncategorized calls
- Block list
- Add a block entry
- Review block list
- Edit a block entry
- Save a caller ID log entry to the block list
- Delete a block entry
- Delete all block entries
- Allow list
- Add an allow entry
- Review allow list
- Edit an allow entry
- Save a caller ID log entry to the allow list
- Delete an allow entry
- Delete all allow entries
- Star name list
- Add a star name entry
- Review star name list
- Edit a star name entry
- Save a caller ID log entry to the star name list
- Delete a star name entry
- Delete all star name entries
- Screening announcement
- Play your current announcement of screening with caller name
- Play your current announcement of screening without caller name
- Record your name for all screening announcements
- Reset all your screening announcements
- Voice guide to set Smart call blocker
- Allowed calls
- Allow calls without numbers
- Allow uncategorized calls
- Blocked calls
- Block calls without numbers
- Block uncategorized calls
- Screen calls without numbers
- Screen uncategorized calls
- Option while on a call
- Sound settings
- About the built-in answering system and voicemail service
- Set your built-in answering system
- Use your built-in answering system
- Use the built-in answering system and voicemail service
- Retrieve voicemail from telephone service
- Expand your telephone system
- Screen messages
- Frequently asked questions
- ECO mode
- General product care
- The RBRC® seal
- FCC, ACTA and IC regulations
- California Energy Commission battery charging testing instructions
- For C-UL compliance only
9
Install the battery
Install the battery as shown below.
• Use only supplied battery.
• Charge the battery provided with this
product only in accordance with the
instructions and limitations specified in this
manual.
• If the handset will not be used for a long
time, disconnect and remove the battery to
prevent possible leakage.
Charge the battery
Place the handset in the telephone base or
the charger to charge.
Once you have installed the battery, the
handset LCD display indicates the battery
status (see the table below).
• For best performance, keep the handset in
the telephone base or charger when not in
use.
• The battery is fully charged after 12 hours of
continuous charging.
• If you place the handset in the telephone
base or the charger without plugging in the
battery, the screen displays No battery.
Battery
indicators
Battery
status
Action
The screen
is blank, or
displays Place
in charger and
flashes.
The battery
has no or very
little charge.
The handset
cannot be
used.
Charge without
interruption
(at least 30
minutes).
The screen
displays
Low battery
and flashes.
The battery
has enough
charge to be
used for a
short time.
Charge without
interruption
(about 30
minutes).
The screen
displays
HANDSET X.
The battery is
charged.
To keep
the battery
charged,
place it in the
telephone
base or charger
when not in
use.
When the battery is fully charged, you can
expect the following performance:
Operation
Operating
time
While in use (talking*) Seven hours
While in speakerphone
mode (talking*)
Three and a
half hours
While not in use (standby**) Five days
* Operating times vary depending on your
actual use and the age of the battery.
** Handset is not charging nor in use.
THIS SIDE UP