Cordless Telephone User Manual

www.vtechphones.com

Basic operation

Answering system

If you have caller

ID service, the

clock will be set

automatically

with incoming

calls, but you will

need to make

sure the year is

correct. See

Set the clock

for instructions

on how to set the

year, time and

day manually.

Press and hold

/SKIP or

/REPEAT

while setting

the minutes or

year to advance

or decrease by

increments of ten.

•

Activate the answering system

The answering system must be turned on to answer and record messages. Press

ANS ON/OFF to turn the answering system on or off. If the answering system is

turned on, it will announce “Calls will be answered,” and the ANS ON/OFF light

will be on. If the answering system is turned off, it will announce “Calls will not

be answered,” and the ANS ON/OFF light will be off.

Set the clock

Prior to playing a message, the answering system announces when it was

received. Before using the answering system, set the year, time and day, so that

messages are dated correctly. If the clock is not set before new messages are

recorded, the system will announce “Time and day not set” before each message

is played to remind you to set the clock.

Press CLOCK. The system announces the clock setting (e.g. year, time and

day), then announces: “To set the clock, press CLOCK.”

Press CLOCK. The system announces the current year.

Press /SKIP or /REPEAT until the system announces the correct year, then

press CLOCK. The system announces the current hour.

Press /SKIP or /REPEAT until the system announces the correct hour, then

press CLOCK. The system announces the current minute.

Press /SKIP or /REPEAT until the system announces the correct minute,

then press CLOCK. The system announces the current day.