Cordless Telephone User Manual
49
Answering system settings
Remote access code
A two-digit security code is required to access the answering system remotely
from any touch-tone telephone. The preset code is 19. You can set the code
from 00 to 99.
Press MENU/SELECT when the handset is not in use.
Press / VOL or VOL/CID to highlight
>
Answering sys, then press
MENU/SELECT.
Press / VOL or VOL/CID to highlight
>
Ans sys setup, then press
MENU/SELECT.
Press / VOL or VOL/CID to highlight
>
Remote code, then press
MENU/SELECT.
Press the dialing keys (0-9) to enter the code, then press MENU/SELECT
to conrm.
Message alert tone
The telephone base beeps every 10 seconds to alert you of new messages.
The tone stops when all new messages have been reviewed.
Press MENU/SELECT when the handset is not in use.
Press / VOL or VOL/CID to highlight
>
Answering sys, then press
MENU/SELECT.
Press / VOL or VOL/CID to highlight
>
Ans sys setup, then press
MENU/SELECT.
Press / VOL or VOL/CID to highlight
>
Msg alert tone, then press
MENU/SELECT.
Press / VOL or VOL/CID to choose
>
On or
>
Off, then press
MENU/SELECT to conrm your selection.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
The answering system must be turned on for the message alert tone
to function.
Press any key on the telephone base (except /FIND HANDSET) to temporarily
silence the message alert tone.
•
•