User`s manual
3
Battery installation
Install the battery as shown below.
If the handset will not be used for a long period of time, disconnect and
remove the battery to prevent any possible leakage.
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the table below). For best performance, keep the handset in the
telephone base or charger when not in use. The battery is fully charged
after 16 hours of continuous charging. Refer to the online user’s manual for
battery operating times.
Battery indicators Battery status Action
The screen is blank,
or displays Place in
charger and ashes.
Battery has very little or
no charge. The handset
cannot be used.
Charge without interruption
(at least 30 minutes).
The screen displays
Low battery and
ashes.
Battery has enough
charge to be used for a
short time.
Charge
without interruption
(about 30 minutes).
The screen displays
HANDSET X and
--:-- --/--.
Battery is charged. To keep the battery charged,
place it in the telephone
base or charger when not
in use.
If you place the handset in the telephone base or charger without plugging in
the battery, the screen displays No battery.
1
CANCEL
CHARGE light
remains on
when charging.
2
3
Plug the battery connector
securely into the socket.
Place the battery with the wires
inside the battery compartment.
Slide the battery compartment
cover towards the center of the
handset until it clicks into place.
Place the handset in the
telephone base or charger
to charge.
4