User`s manual

2
Telephone base and charger installation
Install the telephone base and charger as shown below.
Use only the power adapters and batteries supplied with this product.
To order replacements, visit our website at www.vtechphones.com or call
1 [phone]. In Canada, go to www.vtechcanada.com or call
1 [phone].
CAUTION:
If you subscribe to telephone service from a cable company or a VoIP service provider, contact
your cable/VoIP service provider for more information.
Telephone base
Charger
Telephone base
power adapter
Telephone
line cord
Telephone wall jack
A DSL lter (not
included) is required
if you have DSL high-
speed Internet service.
The DSL lter must
be plugged into the
telephone wall jack.
Charger
adapter
Electrical outlet
(not controlled
by a wall switch)
Battery installation
Install the battery as shown below.
Insert the battery connector
securely into the socket.
1. Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
2.
Slide the battery compartment cover
towards the center of the handset until
it clicks into place.
3.
Place the handset in the telephone
base or charger to charge.
4.
The LCD
backlight
turns on for
10 seconds
to denote the
battery starts
to charge.
IMPORTANT:
Check for a dial tone by pressing . If you hear a dial tone, the installation is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to digital service
from a cable company or a VoIP service provider, the telephone line may need to be
rewired to allow all existing telephone jacks to work. Contact your cable/VoIP service
provider for more information.
•
•