User`s manual

2
Telephone base and charger installation
Install the telephone base as shown below.
Use only the power adapter and battery supplied with this product. To
order a replacement, visit our website at www.vtechcanada.com or call
1 [phone].
The power adapters are intended to be correctly oriented in a vertical or oor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
•
•
Wall mounting (optional)
Your telephone comes ready for tabletop use.
To mount your telephone on the wall:
Position the top hole at the back of
the telephone base against the top
mounting stud [A].
Slide the telephone base down
on the mounting studs [A] and
[B] until it locks into place.
1.
2.
Telephone base
[A]
[B]
Mounting
studs
1
3
2
4
Telephone base
Telephone line cord
Electrical outlet
(not controlled by
a wall switch)
Telephone wall jack
A DSL lter (not
included) is
required if you have
DSL high-speed
Internet service
Telephone base
power adapter
Charger
Charger adapter
Battery installation
Install the battery as shown below.
CHARGE light
remains on
when charging.
Plug the battery connector
securely into the socket.
Place the battery with the wires
inside the battery compartment.
Slide the battery compartment
cover towards the center of the
handset until it clicks into place.
Place the handset in the telephone
base to charge.
If the handset will not be used for a long period of time, disconnect and remove the
battery to prevent any possible leakage.