User`s manual

2
Telephone base and charger installation
Install the telephone base as shown below.
Use only the power adapter and battery supplied with this product. To
order a replacement, visit our website at www.vtechphones.com or call
1 [phone]. In Canada, go to www.vtechcanada.com or call
1 [phone].
The power adapters are intended to be correctly oriented in a vertical or oor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
If you subscribe to telephone service from a cable company or a VoIP service
provider, contact your cable/VoIP service provider for more information.
•
•
•
Telephone base
Telephone line cord
Electrical outlet
(not controlled by
a wall switch)
Telephone wall jack
A DSL lter (not
included) is
required if you have
DSL high-speed
Internet service
Telephone base
power adapter
Charger
Charger adapter
2
4
Battery installation
Install the battery as shown below.
CHARGE light
remains on
when charging.
Plug the battery connector
securely into the socket.
Place the battery with the wires
inside the battery compartment.
Slide the battery compartment
cover towards the center of the
handset until it clicks into place.
Place the handset in the telephone
base to charge.
If the handset will not be used for a long period of time, disconnect and remove the
battery to prevent any possible leakage.
1
3
IMPORTANT:
Check for a dial tone by pressing . If you hear a dial tone, the installation
is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to
digital service from a cable company or a VoIP service provider, the telephone
line may need to be rewired to allow all existing telephone jacks to work.
Contact your cable/VoIP service provider for more information.
•
•