Manual

2
Getting started
Use only the power adapters supplied with this product.
The power adapters are intended to be correctly oriented in a vertical or oor mount
position. The prongs are not designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
Wall mounting (optional)
Your telephone comes ready for tabletop use.
To mount your telephone on the wall:
Position the top hole at the back of the
telephone base against the
top mounting stud [A].
Slide the telephone base
down on the mounting
studs [A] and [B] until it
locks into place.
1.
2.
Telephone base
[A]
[B]
Mounting
studs
Telephone base and charger installation
Install the telephone base and charger as shown below.
If you subscribe to digital subscriber line (DSL) high-speed Internet service through
your telephone line, you must install a DSL lter between the telephone line cord
and telephone wall jack. Contact your DSL service provider for more information
about DSL lter.
Telephone base
Telephone
line cord
Electrical outlet
(not controlled by
a wall switch)
Telephone
wall jack
A DSL lter (not
included) is required
if you have DSL
high-speed Internet
service
Telephone base
power adapter
Charger
Charger
adapter
CAUTION: If you subscribe to telephone service from a cable company or a VoIP
service provider, contact your cable/VoIP service provider for more information.