User`s manual

27
Call log empty
There are no caller ID log entries.
Directory empty
There are no directory entries.
Directory full
The directory is full.
Ended X:XX:XX
You have just ended a call.
Incoming call
There is an incoming call.
Line in use
A system handset is in use, or another telephone on the same
line is in use.
Low battery
The battery needs to be recharged.
Microphone on
MUTE is turned off and the person on the other end can hear you.
Muted
You have turned off the handset microphone. The other party
cannot hear you but you can hear the other party.
New voicemail
There are new voicemail message(s) from the telephone service
provider.
No battery
No battery is installed. Follow the directions for battery installation
on page 4 to install the battery before charging.
No line
There is no telephone line connected.
Not available
One handset is already reviewing the caller ID log and the other
handset tries to review it.
Number repeated
The telephone number you enter is already stored in the
directory.
Out of range or no
pwr at base
The handset cannot communicate with the telephone base.
Check the telephone base power connection or move the handset
closer to the telephone base.
Phone X:XX:XX
The handset is on a call.
Put in charger
The battery is very low. Place the handset in the telephone base
or charger for recharging.
Ringer muted
The handset ringer is muted temporarily during an incoming call.
Ringer off
The handset ringer is turned off.
Saved
Your selection has been saved.
Unable to call.
Failed phone call (the other handset is in use).
XX missed calls
There are calls that have not been reviewed in the caller ID log.
** Paging **
The system handsets are being paged.
Screen messages
Appendix