User`s manual

36
Appendix
Battery
It takes up to 16 hours for the battery to be fully charged. When it is fully charged, you can expect the
following performance:
Operation Operating time
While in use (talking*) Five hours
While not in use (standby**) Six days
*Operating times vary depending on your actual use and the age of the battery.
**Handset is not charging or in use.
The battery needs charging when:
A new battery is installed in the handset.
The handset beeps every minute while on a call.
The handset beeps and LOW BATTERY displays on the handset.
A battery is properly installed and the screen is blank.
CAUTION:
To reduce the risk of re or injury, read and follow these instructions:
Use only the battery(ies) provided or equivalent. To order a replacement, visit our website at www.vtechphones.com or call
1 [phone]. In Canada, go to www.vtechcanada.com or dial 1 [phone].
Do not dispose of the battery(ies) in a re. Check with local waste management codes for special disposal instructions.
Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may cause burns or injury to the eyes or skin. The
electrolyte may be toxic if swallowed.
Exercise care in handling batteries in order not to create a short circuit with conductive materials.
Charge the battery(ies) provided with or identied for use with this product only in accordance with the instructions and limitations
specied in this manual.
Observe proper polarity orientation between the battery and metallic contacts.
To prevent re or shock hazard, do not expose this product to water or any type of moisture.
•
•
•
•
•
•
•
•
•
•
•