User`s manual

Adding the handset to your telephone base

Deregistering a handset

You can deregister handsets. You may need to deregister your

handsets if:

You have twelve registered handsets and need to replace a

handset.

-OR-

You wish to change the designated handset number of your

registered handsets.

You must first deregister ALL the handsets, and then re-register

each handset you wish to use.

Please read carefully through all the instructions on this page

before beginning the deregistration process.

To deregister all handsets

1. Press and hold HANDSET LOCATOR on the telephone base

for about 10 seconds (until the IN USE light starts to flash), then

release the HANDSET LOCATOR button.

2. Immediately press and release HANDSET LOCATOR again.

You must press HANDSET LOCATOR while the IN USE light

is still flashing. (The light flashes for about seven seconds. If the

light stops flashing, pick up the handset and place it back into

the telephone base, then start again with step one above.)

3. The handset(s) shows CONNECTING... and it takes about 10

seconds to complete the deregistration process. ALL handsets

shows NOT REGISTERED when deregistration is successful.

4. To re-register the handset(s) to the telephone base, follow the

registration instructions on page 9.

NOTES:

1. If the deregistration process is not successful, you might need to reset the

system and try again. To reset: pick up the handset and press the

PHONE/FLASH button, then press the OFF/CLEAR button and place

the handset back into the telephone base. You may also reset by unplugging the

power from the telephone base and plugging it back in.

2. You cannot deregister the handset(s) if any other system handset is in use.

3. Even if the battery is depleted, you can still deregister the handset by following

the steps above. After the handset is charged for at least 10 minutes, the screen

shows NOT REGISTERED.