User`s manual

12
I cannot dial out.
Try all the above suggestions.
Make sure there is a dial tone before dialing. It is normal if the handset takes a
second or two to synchronize with the telephone base before producing a dial
tone. Wait an extra second before dialing.
If other telephones in your home are having the same problem, the problem is in
the wiring or telephone service. Contact your telephone service provider (charges
may apply).
Eliminate any background noise. Mute the cordless handset before dialing, or dial
from another room in your home with less background noise.
The answering system does not answer after correct number of rings.
Make sure the answering system is on. When the answering system is on,
the handset shows ANS ON and the /ANS ON/OFF light on the telephone base
is on.
If toll saver is selected, the number of rings changes to two when there are
new messages.
If the memory is full or the answering system is off, the answering system
answers after 10 rings. In some cases, the answering system is affected by the
ringing system used by the telephone service provider.
If you subscribe to voicemail service, change the number of rings so that your
answering system answers before your voicemail answers. To get help with your
voicemail settings, contact your telephone service provider.
If there is a fax machine connected to the same telephone line, try disconnecting
the fax machine. If that solves the problem, consult your fax machine
documentation for information on compatibility with answering systems.
The answering system does not record messages.
Make sure the answering system is on.
Make sure the memory of the answering system is not full. When the answering
machine memory is full, it does not record new messages until some old
messages are deleted.
If you subscribe to voicemail service, change the number of rings so that your
answering system answers before your voicemail answers. To determine how
many rings activate your voicemail, contact your telephone service provider.
If there is a fax machine connected to the same telephone line, try disconnecting
the fax machine. If that solves the problem, consult your fax machine
documentation for information on compatibility with answering systems.
The messages on the answering system are incomplete.
If a caller leaves a very long message, part of it may be lost when the answering
system disconnects the call after the preset recording time.
If the memory on the answering system becomes full during a message, the
answering system stops recording and disconnects the call.
If the caller’s voice is very soft, the answering system may stop recording and
disconnect the call.
I accidentally changed the LCD language to French or Spanish, and I don’t
know how to change it back to English.
While the phone is on a call or not in use, press MENU then enter 364 .
Common cure for electronic equipment.
If the telephone is not responding normally, put the cordless handset in the
telephone base. If this does not x the problem, do the following (in the
order listed):
1. Disconnect the power to the telephone base.
2. Disconnect the battery on the cordless handset.
3. Wait a few minutes before connecting power to the telephone base.
4. Install the battery again and place the cordless handset in the telephone base .
5. Wait for the cordless handset to synchronize with the telephone base. Allow up
one minute for this to take place.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•