User manual

4
Add and register a handset
You can add new handsets to your telephone system. Each
handset must be registered with the telephone base before
use. When rst purchased, each expansion handset shows
To register HS, see manual. The new handset should be
charged without interruption for at least 30 minutes before
registering it to the telephone base.
Make sure the handset is out of the handset charger and is
put near the telephone base. Make sure the handset shows
To register HS, see manual before you begin registration.
To register a handset to your SN1157/SN1196/SN1197/
SN6146/SN6147/SN6196/SN6197 telephone base:
Press MENU on the telephone base
when idle.
Scroll to Settings, then press SELECT.
Scroll to Registration, then press
SELECT. The telephone base shows
Registering... Please wait.
Press QUIET
#
on the cordless
handset. The handset shows
Registering... Please wait. Then
HANDSET X Registered appears on
the cordless handset and the telephone
base, and both devices beep. The handset is now
registered with the telephone base. It takes up to
60 seconds to complete registration.
If registration fails, the telephone base displays
Registration failed and you hear an error tone.
Start again from Step 1 above.
To register a handset to your SN6127/SN6187
telephone base:
Put the handset into the telephone
base. The base IN USE light turns
solid red. The handset shows
Registering... Please wait. Then
HANDSET X Registered appears on
the cordless handset. The handset
beeps and is now registered with
the telephone base. It takes up to
60 seconds to complete registration.
If registration fails, the handset displays Registration failed
and you hear an error tone. Start again from Step 1 above.
1.
2.
3.
4.
•