User`s manual

California Energy Commission battery charging

testing instructions

This pendant is set up to comply with the energy-conserving standards right out of the box. These instructions

are intended for California Energy Commission (CEC) compliance testing only.

When the CEC battery charging testing mode is activated, all telephone functions, except battery charging,

will be disabled.

When first purchased and properly installed for charging (see Pendant charger installation on page 1), put

the pendant on the charger to charge. The CEC battery charging testing mode is activated while charging.

If you have registered the pendant to a telephone base, below are the testing instructions.

To activate the CEC battery charging testing mode:

Unplug the telephone base power adapter from the power outlet. Make sure all handsets are plugged with

charged batteries.

While you press and hold FIND HS or /FIND HANDSET, plug the telephone base power adapter back to

the power outlet.

After about 20 seconds, when the IN USE light starts ﬂashing, release FIND HS or /FIND HANDSET and

then press it again within 2 seconds.

When the phone successfully enters the CEC battery charging testing mode, the IN USE light turns off and

all handsets display To register HS, see manual.

When the phone fails to enter this mode, repeat Step 1 through Step 3 above.

Note: The telephone base will be powered up as normal if you fail to press FIND HS or /FIND HANDSET

within 2 seconds in Step 3.

To deactivate the CEC battery charging testing mode:

Unplug the telephone base adapter from the power outlet, then plug it back in. Then the telephone base is

powered up as normal.