System information

Getting Started 34
AT&T SB67010 Gateway, SB67030 Deskset System Administrator’s Guide
Configuration
Press / in the main menu until Configuration is highlighted and press to
display the Configuration menu. The current setting is indicated with [x]. You can use this interface
or the WEBUI to restore factory defaults and upgrade software. Here are the configuration settings:
 Configuration — Current Gateway settings.
 Auto IP (DHCP) — Is set automatically.
 Static IP — You can change the Static IP only from the Gateway. Although the Gateway
prompts you through the process, using a static IP address can have serious effects, so
contact your installer if Static IP editing is required.
 Restore Defaults — Highlight Restore Defaults, and press . Press and hold
for two seconds when prompted. See Backup/Restore Settings on page 91 before restoring
factory defaults.
 Upgrade Software — For upgrading software, just highlight Upgrade Software, and press
. If new software is available, you are prompted to press again to accept the
upgrade.