User`s manual

TROUBLESHOOTING

Remove the battery and then install it again. Turn on the baby unit

and the parent unit. Allow up to one minute for the parent unit and

the baby unit to synchronise.

Other electronic products may cause interference with your video

and audio monitor. Try installing your video and audio monitor as far

away from these electronic devices as possible: wireless routers,

radios, cellular telephones, intercoms, room monitors, televisions,

personal computers, kitchen appliances and cordless telephones.

The light and LOW BATTERY ash on the parent unit.

Charge the battery in the parent unit for up to 12 hours.

Remove the battery and then install it again. Use it until fully

depleted, then recharge it in the parent unit for up to 12 hours.

If the above measures do not correct the problem, replace the

battery.

The battery does not charge in the parent unit or the parent unit

battery does not accept charge.

Make sure the battery is installed in the parent unit battery

compartment correctly. The light on the parent unit should be on

when charging.

Remove the battery and then install it again, then charge for up to

12 hours.

If the battery icon and the light on the parent unit are not on,

refer to The light on the parent unit is off below.

If the battery is completely depleted, it may take up to 30 minutes to

charge the parent unit before it can be used for a short time

(page 14).

Purchase a new battery. Refer to Parent Unit Battery Installation

(pages 11-12) and Parent Unit Battery Charging (page 14).

The light on the parent unit is off.

Make sure the parent unit battery is installed (pages 11-12) and

charged (page 14) correctly.

The light is off when the battery is fully charged even if it is also

•