User`s manual

SET UP THE BABY MONITOR

2.4 Parent Unit Battery Installation

You can power up the parent unit by connecting it to AC power or to the

rechargeable battery provided. Even if the parent unit is connected to

AC power, we recommend you also install the battery. This guarantees

continual operation in case of a power outage.

Install the battery as shown below.

With the label THIS SIDE UP facing up, insert the small tabs of the

battery into the slots inside the battery compartment. Make sure the

metallic contact is correctly oriented as shown below. Push the battery

into the battery compartment until it clicks securely into place.

Align the battery compartment cover at against the battery

compartment, then slide it towards the center of the parent unit until

it clicks into place.

Metallic

contact