User`s manual

30
Other electronic products may cause interference with your video
and audio monitor. Try installing your video and audio monitor as far
away from these electronic devices as possible: wireless routers,
radios, cellular telephones, intercoms, room monitors, televisions,
personal computers, kitchen appliances and cordless telephones.
The light and LOW BATTERY ash on the parent unit.
Charge the battery in the parent unit for up to 12 hours.
Remove the battery and then install it again. Use it until fully
depleted, then recharge it in the parent unit for up to 12 hours.
If the above measures do not correct the problem, replace the
battery.
The battery does not charge in the parent unit or the parent unit
battery does not accept charge.
Make sure the battery is installed in the parent unit battery
compartment correctly. The light on the parent unit should be on.
Completely remove and install the battery again, then charge for up
to 12 hours.
If light on the parent unit is not on, refer to The light on the
parent unit is off below.
If the battery is completely depleted, it may take up to 30 minutes to
charge the parent unit before it can be used for a short time
(page 11).
Purchase a new battery. Refer to Parent unit battery installation
(pages 8-9) and Parent unit battery charging (page 11).
The light on the parent unit is off.
Make sure the parent unit battery is installed (pages 8-9) and
charged (page 11) correctly.
Make sure the power adapter and the parent unit are plugged in
correctly and securely.
Unplug the parent unit power adapter. Wait for 15 seconds before
plugging it back in. Allow up to one minute for the baby unit and
parent unit to reset.
The parent unit beeps and is not performing normally.
Make sure the baby unit is turned on.
•
•
•
•
•
•
•
•
•
•
•
•
•