User`s manual

29
TROUBLESHOOTING
The video and audio monitor produces high-pitched noise.
The parent unit may be too close to the baby units. Make sure the parent
unit and the baby units are at least 1 metre away from one another.
You may be too close to the baby unit when you press and hold
TALK. Make sure the parent unit and the baby units are at least
1 metre away from one another.
You may have set the sensitivity level too high. You may need to
adjust the sensitivity level to a lower level to avoid audio feedback
(page 19).
The parent unit plays any sounds from the baby unit and I think it is
too noisy.
You may have set the sensitivity level to Level 5 (Maximum). If you
do so, the baby unit will transmit any sounds detected to the parent
unit. You may need to adjust the sensitivity level to a lower level
(page 19).
You may need to adjust the speaker volume on the parent unit
(page 25).
The parent unit does not play any sound when there is noise from
the baby unit.
Make sure the parent unit is powered up by connecting it to AC
power (page 10) or to the rechargeable battery provided (page 11).
Make sure the parent unit is turned on (page 25) and the speaker
volume is not set to off (page 25).
The parent unit may be too far away from the baby unit. Move the
parent unit closer to the baby unit (but not less than 1 metre).
If the parent unit is powered by the provided battery, make sure there is
sufcient charge. Charge the battery in the parent unit for up to 12 hours.
You may have set the sensitivity level to a very low level. If you do
so, the baby unit will not detect sounds that is too soft or light. You
may need to adjust the sensitivity level to a higher level (page 19).
Large obstructions may impact the reception. Try to relocate the
baby unit, away from large obstructions such as walls and doors.
Remove the battery and then install it again. Turn on the baby unit
and the parent unit. Allow up to one minute for the parent unit and
the baby unit to synchronise.
•
•
•
•
•
•
•
•
•
•
•
•