User`s manual

11
SET UP THE BABY MONITOR
2.6 Parent unit battery charging
Once you have installed the parent unit (see page10) and its battery
(see page 8), press for 2 seconds to turn it on. The battery icon
indicates the battery status (see the table below). The parent unit battery
is fully charged after 12 hours of continuous charging.
When the parent unit is operating in battery mode and the battery is low,
you need to charge the parent unit without interruption for at least
30 minutes to give the parent unit enough charge to use for a short time.
When operating in low battery condition, the parent unit displays . The
light on the parent unit flashes and the parent unit plays short beeps
to alert you.
The following table summarizes the battery charge indicators and
actions to take.
Battery
indicators
Battery status Action
The battery icon is
off and displays.
No battery is
installed but operates
using AC power, or
the battery has been
installed incorrectly.
Install the parent unit
battery. Charge without
interruption (at least
30 minutes).
The screen
displays . The
light flashes.
The battery has very
little charge and may
be used for only a
short time.
Charge without
interruption (about
30 minutes).
The battery icon
becomes solid .
The battery is fully
charged.
To keep the battery
charged, connect it to
AC power when not in
use.
Note
When you charge the battery initially or it is not used for a long period of time,
charge it for 12 hours continuously. It takes longer to charge the battery when the
parent unit is turned on. To shorten the charging time, turn the parent unit off while
charging.