User`s manual

respective owners. THIS PRODUCT IS NOT ENDORSED OR SPONSORED
BY ADOBE SYSTEMS INCORPORATED, PUBLISHER OF FLASH
SOFTWARE INSTALLATION
Before you can connect the VTech
®
ABC Learning Classroom™ to your
computer, you need to install the the Learning Lodge Navigator™ software on your
computer. To obtain the Learning Lodge Navigator™, please go to the VTech
®
ABC
Learning Classroom™downloadsiteonhttp://www.vtechkids.com/download/
and download the setup file.
Once the setup process is complete, connect the VTech
®
ABC Learning
Classroom
™ to the computer using a USB cable. Locate the USB jack on the
right side of your product, and plug the device into your computer’s USB port.
Note:
1. If the power supply is interrupted during the transfer of data to the VTech
®
ABC Learning Classroom™, the data on the VTech
®
ABC Learning
Classroom™ may be lost. Before connection, please check and make sure
that your batteries are not running low on power.
2. Refrain from unplugging the USB cable during
the transfer of data to the VTech
®
ABC Learning
Classroom™. This may cause the data to
transfer abnormally or be lost.
If the VTech
®
ABC Learning Classroom™ is connected properly, you will be
taken directly to the VTech
®
Learning Lodge Navigator™ website, where you
can enjoy all of the online features.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat source.
3.Removethebatterieswhentheunitisnotinuseforanextendedperiod
of time.
4.Donotdroptheunitonahardsurfaceanddonotexposetheunitto
moisture or water.
SOFTWARE INSTALLATION/CARE & MAINTENANCE
7