Manualshelf

User`s manual

ManualsBrandsVTech ManualsBaby CareAlphabert and Sprocket
27282930313233343536
Thomas, ET, Juliet Classic, Juliet Pro, Juliet Pro 60 33
Enter 5.1E on the keypad while staying on-line. Send your file from your
computer. After the first completed sheet ejects, stay on-line. Insert the
next sheet. Enter 2E on the keypad to set the top-of-form. (2E works on-line
in Single Sheet Mode.) Repeat until the entire file has been embossed. Leave
Single Sheet Mode by entering 5.0E on the embosser's keypad.
Service Menu
This menu contains special functions often used in the testing, aligning, and
troubleshooting of the embosser by service personnel, but some are also
useful in daily operation.
You enter the service menu by going off-line with the OL key, then typing
0.0E. Some of the functions exit automatically when they are completed,
and these are labeled "Auto" in the right most column. The others will remain
active until you press any key to stop them. Leave the Service Menu by
pressing the E key until you hear a series of beeps, which brings you back to
the off-line level.
SEQUENCE FUNCTION EXIT
1E System reset AUTO
2E Print test pattern (E 5 pattern) ANY KEY
3E Print 6 dot pattern (equal signs) ANY KEY
4E Carriage motor on high power ANY KEY
5E Line-feed motor on high power ANY KEY
6E Top-of-form sensor test (tone) ANY KEY
7E Paper-out sensor test (tone) ANY KEY
8E Home sensor alignment (0=1 step left, .=1 step right) ANY
OTHER KEY
9E Print test documentation ANY KEY
10E Print keypad and all settings ANY KEY
11E Print graphics mode test ANY KEY
15E Speak (with ET Speaks) firmware version or press 1 to print
out firmware revision number in grade 2 AUTO
20E Low Power/E
NERGY STAR® Mode Inactive AUTO
21E Low Power/E
NERGY STAR® Mode Active AUTO
22E Low Power/E
NERGY STAR® Mode Test ANY KEY
40E Home sensor offset (0=negative, .=positive step) E KEY
90E Activate delay before emboss routine (0E-12E) AUTO
91E Activate delay before emboss in Jumbo (0E-30E) AUTO
95E Load defaults into NOV-RAM AUTO
96E Zero the NOV-RAM checksum AUTO
98E Calculate new checksum AUTO
99E Verify the NOV-RAM checksum (Dirge if fail) AUTO