User`s manual

Thomas, ET, Juliet Classic, Juliet Pro, Juliet Pro 60 30
Menus
Enter a Menu
OL Takes the embosser off-line
0.NE Go to menu N (1 through 16)
Menu Settings & What They Do
1.0E Make this menu the power-on default
1.1E Exit and make this menu current
2.0E Selects serial port
2.1E Selects parallel port
3.NE Sets baud rate to N. Available baud rates from 45.5 to
38,400. Example: Change to 9600 by keying 3.9600E
4.NE Sets the number of data bits to N. Available data bits: 5, 6,
7 and 8
5.NE Sets the number of stop bits to N. Available stop bits: 1,
1.5 and 2
6.NE Selects parity (0 = none, 1 = odd, 2 = even)
7.NE Sets communication code (0 = ASCII, 1 = Baudot)
8.NE Sets handshaking (0=Xon/Xoff, 1=DTR & CTS, 2=DTR & DSR,
3=RTS & CTS, 4=RTS & DSR)
9.NE Braille mode (0 = 6 dot, 1 = 8 dot)
10.NE Word wrap (0 = off, 1 = on)
11.NE Perf skip (0 = off, 1 = on)
12.NE Paper-out detector (0 = off, 1 = on)
13.NE Auto LF mode (0=none, 1=xmit, 2=rcv, 3=xmit & rcv)
14.NNE Set right margin to N
15.NNE Set left margin to N
16.NE Emboss control characters (0 = off, 1 = on)
17.NNE Set lines per page to N
18.NNE Set page length to N (1.0 inch increments)
19.NE Set multi strike count to N. Also, multi strike count can be
increased while on-line as well. Stay on-line and enter
9.NE. "N" ranges from 1 (light) to 3 (heavy) strikes.
Warning: Multiple strikes dramatically slow (and may
eventually damage) embosser when used with light
material
20.NE Enter character N into control character table